Bumper cuts are cut on the underside of the bumper.
None visible : the cut will not be visible unless you look up at the bumper from the ground.
Visible: the cut will be visible when standing behind the vehicle.
No cut: No cutting required.
:
No
Bypass Required
Many modern vehicles require a bypass relay for the towbar electrics to work correctly. If your vehicle requires this relay then damage can occur to the cars electrics if one isn't fitted.
Our data is collected from the tow bar and tow bar wiring manufacturers with regards to whether your vehicle needs a bypass relay.
:
No
Towing Weight Kg
This is the maximum weight that the vehicle can tow.
:
1850
Nose Weight Kg
This is the maximum weight that the placed on the ball, ie the average adult bike weighs around 15KG, 15 x 4 = 60 KG and a cycle for 4 bikes is around 20KG = 80KG.
Return and exchange As a PF Jones customer, if you no longer want the items you have 14 days to cancel your order or inform us you would like to return the goods.
Mitsubishi pinin 3 door equippe registration SO 05 KXR. The chassis does not have on the offside M12 x 1.25 threaded nuts within the chassis unlike earlier year models. There seems to be two straight through holes instead. The Witter instruction manual doesn't show how the off side is then secured. Can you advise please
Asked by Geoff Shaw | 23/02/2016, 10:44 | 5 answer(s)
Hi Geoff, it sounds to me that it could be an Import model there's no easy answer for you other than modifying something on the vehicle, I can not guarantee this will fit perfectly.
Kind regards
Adam
Many thanks for your prompt reply. I initially thought that it was a one off on the vehicle I have but then checked on another 2005 vehicle of the same make. That also didn't have the offside nuts in the chassis. Would you consider that putting two M10 bolts though the aligned holes and then fitted with secured washers, nuts and torqued would do the job?
With king regards
Answered by Geoff Shaw | 23/02/2016, 03:04Add answer
Hi Geoff, I have spoken to Witter technical and they say it should be fine with good grade bolts but be aware as the vehicle may not have a towing capacity on the VIN plate if it is an import.
Kind regards
Adam
Thank you very much for your help on this. Where do I find the VIN plate to check?. There is a general 1850kg on the witter literature for the registration SO 05 KXR, but this probably applies to the tow bar
Looking at the tow bar- if I add a third hole on the outer plate, then I can fit three bolts of about 75mm through the chassis and tow bar faces.
That should work- only used for towing trailer to refuge tip
Thanks again
With kind regards
Answered by Geoff Shaw | 24/02/2016, 08:39Add answer
Hi Geoff, there should be a couple of weights on the VIN plate
you need to deduct the weight of the car from the gross train weight and the difference is what you can tow.
Kind regards
